The TKFS Native Slayer Propel Steering Upgrade Kit is for Slayers made in 2015 and older and comes with 1/8″ stainless steel cable and two new retention pins to accommodate the larger diameter cable. The replacement is easy to do and this kit ships USPS Priority within 24 hours. We’ll be adding a short video to assist with the replacement soon….
To replace your cable, with your Native Slayer Propel Steering Upgrade Kit you will need the following tools;
Wire cutters, 2mm Alan Key, Philips screwdriver and retention clip pliers (or some work around for the clips)
We like to start by opening the steering control box (port side). Then, remove the rudder, and loosen the set screws keeping the cable in place on the rudder disc. If your Propel is a 2016 or newer, you will not need to remove the retention clips. You can simply reuse the ones you already have. Now, remove all of the old cable.
We like to feed the cable from the steering box toward the rudder. Please note, the steering cable is one continuous length. Do not cut into two!!!
Once your cable is replaced, we reinstall the rudder without the rudder screw. This gives us the leverage to pull tension on the steering cable while we tighten the 2mm set screw. Keep an eye on your steering handle as you want to install the cable and have your steering be in the center! Once the cable retention screws are tight, you can remove the rudder and trim the steering cable to length. Reinstall the rudder and go fishing!!!
If your kayak is year 2016 or newer, you just need a replacement cable CLICK HERE
Check out some of our other exclusive Native steering products Click Here